Staking An Amaryllis: Types Of Amaryllis Support Stakes

Red Amaryllis Flower Staked for Extra Support
amaryllis staking
(Image credit: Latvian)

Gardeners love amaryllis (Hippeastrum sp.) for their simple, elegant blossoms and their fuss-free cultural requirements. The tall amaryllis stalks grow from bulbs, and each stalk bears four huge blooms that are excellent cut flowers. If your blooming plant gets top-heavy, you might need to learn about staking an amaryllis. Read on for information about what to use for amaryllis plant support.

Staking an Amaryllis

You’ll have to start staking an amaryllis when the stems threaten to topple under the weight of the flowers. This is especially likely if you are growing a cultivar that offers large, double blossoms, like ‘Double Dragon.’ The idea behind staking amaryllis plants is to provide them with amaryllis support stakes that are stronger and sturdier than the stems themselves. On the other hand, you don’t want to use anything so big that the amaryllis plant support detracts from the beauty of the long-legged flower.

Ideal Support for Amaryllis

The support for amaryllis plants must include two parts. Your amaryllis plant support stake must have both the stake that is inserted into the ground beside the stem and also something attaching the stem to the stake. Ideal amaryllis support stakes are about the thickness of a wire clothes hanger. You can buy them in commerce, but it is cheaper to make your own.

Making Amaryllis Support Stakes

In order to create a stake for supporting an amaryllis, you need one wire clothes hanger, plus wire clippers and a pair of needle-nose pliers. Be sure to choose a sturdy hanger, not a flimsy one. Clip off the top section (the hanger section) from the clothes hanger. Straighten out the wire using the needle-nose pliers. Now create a rectangle at one end of the wire. This will attach the plant stems to the stake. The rectangle should end up 1.5 inches (4 cm.) wide by 6 inches (15 cm.) long. Use the needle-nose pliers to make 90-degree bends in the wire. Make the first bend at 2.5 inches (6 cm.) instead of 1.5 inches (4 cm.), to allow sufficient wire for a clasp. Make the second 90-degree bend 6 inches (15 cm.) later, the third should be 1.5 inches (4 cm.) after that. Bend back the first inch (2.5 cm.) of the 2.5 inch (6 cm.) segment in a U-shape. Then bend the entire rectangle so it is perpendicular to the length of the wire with the open side facing up. Insert the bottom end of the stake into the “leaf edge” side of the bulb. Push it in close to the bulb nose and keep pushing until it touches the bottom of the pot. Open the “latch” of the rectangle, gather flower stems into it, then close it again.

Teo Spengler
Writer

Teo Spengler has been gardening for 30 years. She is a docent at the San Francisco Botanical Garden. Her passion is trees, 250 of which she has planted on her land in France.