By Stan V. (Stan the Roseman) Griep
American Rose Society Certified Consulting Rosarian – Rocky Mountain District
Transplanting roses really is not much different than planting a budded and blooming rose bush from your local greenhouse or garden center except that the rose bush to be moved is still in its dormant state for the most part. Below is listed the instructions for how to transplant roses.
Best Time To Transplant Rose Bush
I prefer to start transplanting rose bushes in early spring around about the middle to end of April if the weather is nice enough to be able to dig the soil. Early May still works as a good time when to transplant roses, if the weather is still rainy and cool but the point is to transplant rose bushes early on in spring before the rose bushes get fully out of their dormant state and start growing well.
How To Transplant A Rose Bush
First you will need to select a good sunny spot for your rose bush or rose bushes, paying attention to the soils at the selected site. Dig the hole for your new rose 18 to 20 inches in diameter and at least 20 inches deep, sometimes 24 inches if you are moving an older bush.
Place the soils taken from the planting hole in a wheel barrow where they can be amended with some compost as well as about three cups of alfalfa meal (not the rabbit food pellets but actual alfalfa meal).
I use a hand cultivator and scratch up the sides of the planting hole as it can become very compacted while digging the planting hole. Fill the hole about half full with water. While waiting for the water to soak away the soils in the wheel barrow can be worked with a garden fork to mix in the amendments at about a 40% to 60% ratio with the original soils being the higher percentage.
Before digging out the rose bush to be moved prune it down to at least half its height for hybrid tea, floribunda and grandiflora rose bushes. For Shrub rose bushes prune them just enough to make them more manageable. The same manageable pruning holds true for climbing rose bushes, just keep in mind that excessive pruning of some climbers that bloom on the last seasons growth or “old wood” will sacrifice some blooms until the following season.
I start my digging 6 to 8 inches out from the base of the rose bush going all the way around the rose bush forming a circle where I have pushed the shovel blade as far down as it will go at each point, rocking the shovel back and forth a bit. I continue this until I have gained a good 20 inch depth, each time rocking the shovel back and forth a bit more so as to loosen the root system up. You will cut some roots but will also have a nice sized root ball to transplant.
Once I have the rose up out of the ground I brush off any old leaves that may be around the base and also check for other roots that do not belong to the rose and as gently as possible remove those other roots. Many times I find some tree roots and they are easy to tell that they are not part of the rose bushes root system due to their size.
If I am moving the rose bush to another place a few blocks or several miles away, I will wrap the root ball with an old bath or beach towel that is well moistened with water. The wrapped root ball is them placed in a big trash bag and then the entire bush into my truck or car trunk. The moistened towel will keep the exposed roots from drying out during the trip.
If the rose is just going to the other side of the yard I load it either in another wheel barrow or onto a wagon and take it directly to the new planting hole.
The water I filled the hole halfway with is usually all gone by now, if for some reason it is not I may have some drainage problems to address once I get the rose bush planted.
I place the rose bush into the hole to see how it fits (for the long moves, don’t forget to remove the wet towel and bag!!). Usually the planting hole is a bit deeper than it needs to be as either I dug it a bit deeper or did not get a full 20 inches of root ball. I take the rose bush back out of the hole and add some amended soils to the planting hole to make a nice base for its support and for the root system to sink down into.
In the bottom of the hole, I mix in about ¼ cup of either super phosphate or bone meal depending on what I have on hand. I place the rose bush back into the planting hole and fill in around it with the amended soils. At about half full I give the rose some water to help settle it in. Then continue filling the hole with the amended soils ending by forming a little bit of a mound up onto the base of the bush and a little bowl shape around the rose to catch rain water and other watering that I do. Finish by watering lightly to settle the soils in and help form up the bowl around the rose and add some mulch.
Print This Article - Printer Friendly Version
Helpful?:
Loading ...
By Stan V. (Stan the Roseman) Griep
American Rose Society Certified Consulting Rosarian – Rocky Mountain District
Best Time To Transplant Rose Bush
I prefer to start transplanting rose bushes in early spring around about the middle to end of April if the weather is nice enough to be able to dig the soil. Early May still works as a good time when to transplant roses, if the weather is still rainy and cool but the point is to transplant rose bushes early on in spring before the rose bushes get fully out of their dormant state and start growing well.
How To Transplant A Rose Bush
First you will need to select a good sunny spot for your rose bush or rose bushes, paying attention to the soils at the selected site. Dig the hole for your new rose 18 to 20 inches in diameter and at least 20 inches deep, sometimes 24 inches if you are moving an older bush.
Place the soils taken from the planting hole in a wheel barrow where they can be amended with some compost as well as about three cups of alfalfa meal (not the rabbit food pellets but actual alfalfa meal).
I use a hand cultivator and scratch up the sides of the planting hole as it can become very compacted while digging the planting hole. Fill the hole about half full with water. While waiting for the water to soak away the soils in the wheel barrow can be worked with a garden fork to mix in the amendments at about a 40% to 60% ratio with the original soils being the higher percentage.
Before digging out the rose bush to be moved prune it down to at least half its height for hybrid tea, floribunda and grandiflora rose bushes. For Shrub rose bushes prune them just enough to make them more manageable. The same manageable pruning holds true for climbing rose bushes, just keep in mind that excessive pruning of some climbers that bloom on the last seasons growth or “old wood” will sacrifice some blooms until the following season.
I start my digging 6 to 8 inches out from the base of the rose bush going all the way around the rose bush forming a circle where I have pushed the shovel blade as far down as it will go at each point, rocking the shovel back and forth a bit. I continue this until I have gained a good 20 inch depth, each time rocking the shovel back and forth a bit more so as to loosen the root system up. You will cut some roots but will also have a nice sized root ball to transplant.
Once I have the rose up out of the ground I brush off any old leaves that may be around the base and also check for other roots that do not belong to the rose and as gently as possible remove those other roots. Many times I find some tree roots and they are easy to tell that they are not part of the rose bushes root system due to their size.
If I am moving the rose bush to another place a few blocks or several miles away, I will wrap the root ball with an old bath or beach towel that is well moistened with water. The wrapped root ball is them placed in a big trash bag and then the entire bush into my truck or car trunk. The moistened towel will keep the exposed roots from drying out during the trip.
If the rose is just going to the other side of the yard I load it either in another wheel barrow or onto a wagon and take it directly to the new planting hole.
The water I filled the hole halfway with is usually all gone by now, if for some reason it is not I may have some drainage problems to address once I get the rose bush planted.
I place the rose bush into the hole to see how it fits (for the long moves, don’t forget to remove the wet towel and bag!!). Usually the planting hole is a bit deeper than it needs to be as either I dug it a bit deeper or did not get a full 20 inches of root ball. I take the rose bush back out of the hole and add some amended soils to the planting hole to make a nice base for its support and for the root system to sink down into.
In the bottom of the hole, I mix in about ¼ cup of either super phosphate or bone meal depending on what I have on hand. I place the rose bush back into the planting hole and fill in around it with the amended soils. At about half full I give the rose some water to help settle it in. Then continue filling the hole with the amended soils ending by forming a little bit of a mound up onto the base of the bush and a little bowl shape around the rose to catch rain water and other watering that I do. Finish by watering lightly to settle the soils in and help form up the bowl around the rose and add some mulch.
Print This Article - Printer Friendly Version
TweetMore Information:
Didn't find the answer to your question? Ask one of our gardening experts.
Do you know anything about gardening? Help answer someone's gardening question.
Read more articles in Flower Gardening.
You might also be interested in these articles: